Skip to content
Back to lessons

22. · 7 min

3-style edges

Lesson overview
  • Solve a pair of edge targets with one commutator
  • Use slice moves as insertions and interchanges
  • Recognise a 3-style edge case from the buffer UF

Builds on: 3-style corners

Before you start
  • A 3-style case is an ordered pair of targets, solved by one commutator.
  • The interchange is a single turn; the insertion brings a piece into its slot and back out.

Edges work the same way as corners: every pair in the edge memo is one commutator that cycles the buffer and two targets. What's new is the moves the comms are built from.

The buffer

This site's 3-style edges use the buffer UF. From UF there are 440 edge cases, each with a verified commutator.

Slices do a lot of the work

Edge comms often use the middle slices, M, S and E, as the interchange or inside the insertion, because a slice turn moves edges between faces without touching any corner.

Loading the cube…

That comm's interchange is a slice turn. Many edge cases are like it: short, with a slice doing the swap.

Cases on the same layer often need a setup first:

Loading the cube…

Flipped edges

An edge in its slot but flipped isn't a 3-cycle, so it isn't a commutator case. Like twisted corners, flipped edges have their own verified algs; learn them after the cycles.

Where to start

The same route as corners works: pure comms first, then cases by setup, and each case together with its inverse. If you already use M2, cases on the M slice will look familiar.

Checkpoint: Recognise edge cases

Loading the cube…

How should lessons talk to you?

Pick a voice. The facts are the same in every one, and you can switch any time from the lesson header or Settings.

A local-only cubing workbench.Small steps. Deeper understanding.Contact · Privacy