Skip to content
Back to lessons

13. · 8 min

Old Pochmann edges

Lesson overview
  • Perform the edge swap from the buffer to the swap spot
  • Find a setup for any edge target using D, L, Dw and Lw
  • Explain which moves are forbidden for edges, and why

Builds on: Old Pochmann corners

Before you start
  • A corner target is shot with a setup of D, R or F turns, the corner swap, and the undo. U, L and B are forbidden because they move the buffer or the side-effect edges.

Edges work the same way as corners: one swap, and setups that bring each target to the swap spot. Only the pieces, the swap and the allowed moves change.

The swap

The edge swap exchanges the buffer, …, with the swap spot, the top-left edge's top sticker: UL, … in your scheme. Its side effect swaps two top-layer corners, UBR and UFR.

R U R' U' R' F R2 U' R' U' R U R' F'

It's 14 moves, and if you've learnt last-layer algorithms before, you may recognise it as the T permutation. A target already on the swap spot needs no setup:

Loading the cube…

Setups

Setups for edges may use D, L, Dw and Lw: the bottom face, the left face, and the wide versions of both. Dw turns the bottom face with the E layer; Lw turns the left face with the M layer. That's what lets an edge from the middle layer or the far side of the cube reach the swap spot without touching the top-right.

Most edge targets take two or three moves; a few take one, and one takes four. Some examples:

Loading the cube…

Loading the cube…

Loading the cube…

The usual pattern: get the target into the left face with D or Dw moves, then turn the left face (L or Lw) so the target lands in the top-left on the top sticker.

What's forbidden, and why

The swap needs the buffer UR and the corners UBR and UFR left where they are. So:

  • U and R (and their wide versions) move the buffer and both corners.
  • F moves UFR; B moves UBR.

Here's what goes wrong with a U setup:

Loading the cube…

Checkpoint: Edge setups

Loading the cube…

How should lessons talk to you?

Pick a voice. The facts are the same in every one, and you can switch any time from the lesson header or Settings.

A local-only cubing workbench.Small steps. Deeper understanding.Contact · Privacy