Skip to content
Back to lessons

17. · 7 min

M2 edges: every special case

Lesson overview
  • Shoot UF, FU, DB and BD with their own algs
  • Apply the odd/even rule on the second letter of a pair
  • Explain why that rule exists

Builds on: M2 edges: the idea

Before you start
  • M2 exchanges the buffer DF with UB, and also swaps UF with DB.
  • A legal setup leaves DF, UF and DB home when M2 runs.

UF and DB are the two edges M2 swaps besides the buffer and UB. A setup can't bring either to UB and still leave them home for the swap, so each has its own alg, one per sticker: UF, FU, DB and BD.

The four algs

Each one does what a setup, M2 and undo would do if that were possible: the buffer's piece goes to the target, and the slice ends in the same state as after a normal M2.

Loading the cube…

Loading the cube…

Loading the cube…

Loading the cube…

Learn them in pairs: UF with DB, and FU with BD. Each pair belongs together because of the rule below.

The odd/even rule

Every M2 turns the slice a half turn. After an odd number of them, the slice is still out: the piece that belongs at UF is sitting at DB, and the piece that belongs at DB is sitting at UF.

So when one of these four targets is the second letter of a pair, an odd number of M2s has just been done, and you shoot it as its partner:

  • UF as the second letter: do DB's alg;
  • DB as the second letter: do UF's alg;
  • FU as the second letter: do BD's alg;
  • BD as the second letter: do FU's alg.

As the first letter of a pair, each one is shot with its own alg.

The M2/OP trainer has a special-case drill that asks each of the eight cases, four targets in two positions, until they stick.

Checkpoint: M2 special cases

Loading the cube…

How should lessons talk to you?

Pick a voice. The facts are the same in every one, and you can switch any time from the lesson header or Settings.

A local-only cubing workbench.Small steps. Deeper understanding.Contact · Privacy