Skip to content
Back to lessons

4. · 6 min

Last layer — orient first, then permute

Lesson overview
  • Tell orientation from permutation on the last layer
  • Recognise the two stages of a two-look last layer
  • Hold a case so the algorithm you have starts from the right picture

Builds on: Beginner F2L — turn an awkward pair into a familiar one

Before you start
  • F2L ends with the first two layers solved and protected.
  • The last layer is the yellow layer on top.

The last layer has two separate jobs, and mixing them up is the commonest reason a case looks confusing.

Orientation asks: is the sticker on top yellow? A piece can be in the wrong place and still be oriented. Permutation asks: is each piece in the right place? A piece can be in the right place and still be twisted the wrong way.

The order matters. Get every top sticker yellow first (OLL, for orientation of the last layer). Only then look at where the pieces are (PLL, for permutation of the last layer). Once the top is all yellow, the top face tells you nothing more, so the side colours are what you read.

Orientation done, permutation left

This cube has just finished OLL. The top is all yellow, but the pieces are not in their places. Play it and watch the top face: it turns fully yellow after the first sequence and stays yellow, and then the algorithm changes only where the pieces are.

Now the cube looks like this. The side colours show that two pieces are swapped, which is the permutation still to fix.

Two looks or one

Learning all 57 orientation cases and all 21 permutation cases is a big job, so there is a smaller route: two-look.

  • Two-look OLL orients the edges first (3 pictures), then the corners (7 pictures).
  • Two-look PLL permutes the corners first (2 pictures), then the edges (4 pictures).

That is 16 pictures instead of 78, and it finishes the same cube. Full OLL and full PLL do each stage in one algorithm and are faster, but you can add them one case at a time whenever you like.

Hold the case, then turn

Every case card on this site shows the case exactly as its algorithm expects, with yellow on top. If your cube looks like the card turned sideways, turn the top layer (a U turn) until it matches, or hold the cube so it does. The cards say which. When an algorithm needs a turn before or after it, that is written on the card too.

Checkpoint: Last-layer stages

Loading the cube…

Which comes first on the last layer?
After OLL, what do the side stickers of the top layer show you?
Two-look OLL needs how many pictures?

How should lessons talk to you?

Pick a voice. The facts are the same in every one, and you can switch any time from the lesson header or Settings.

A local-only cubing workbench.Small steps. Deeper understanding.Contact · Privacy